Audi A8 Workshop Manual page 90

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Fit corrugated spring -2- in cylinder „E" -item 1-.
– Fit outer plates -3- and friction plates -4- alternately.
– Insert thick outer plate -5-.
– Insert circlip -6-.
Adjusting clearance of clutch „E"
– Clamp support leg of compressor tool -T10285- in vice.
– Insert clutch „E" in compressor tool.
• The input shaft projects out of drilling in base plate.
– Place holding plate -T10279- on outer plate of clutch „E".
• Avoid any contact between holding plate and circlip.
– Fit centring pin of thrust piece -T10285/1- into drilling in holding
plate.
– Bring clutch „E" into correct position on base plate of com‐
pressor tool.
• Thrust piece must be positioned centrally below thrust plate of
spindle.
– Turn spindle of compressor tool downwards.
• The markings on the inspection hole of the thrust piece must
align -arrow-.
– Insert dial gauge -VAS 6080- into measuring bridge -VW
382/7- and secure with knurled nut.
– Position measuring bridge on upper rim of cylinder „E" as
shown in illustration.
– Check that measuring bridge is seated properly on rim of cyl‐
inder „E".
– Bring measuring tip into contact with outer plate and note value
obtained.
– Mark exact contact point on cylinder „E".
– Repeat measurement at two other points on outer plate (offset
by 120°) and mark measuring points.
– Determine average value from the three measurements under
load.
– Release spindle and remove holding plate.
86
Rep. gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.