Renewing Oil Seal For Flange Shaft (Rear) - Audi A8 Workshop Manual

– Press ball bearing onto centre differential.
– Press ball bearing -A- onto centre differential as far as stop
using workshop press in conjunction with assembly tool
-3350- .
– Install centre differential housing
2.4

Renewing oil seal for flange shaft (rear)

Procedure
– Remove centre differential housing
– Remove circlip -arrow- on inner side of cover.
Note
The circlip locates the flange shaft on the bearing in the cover.
– Using press tool -VW 409- , press flange shaft out of centre
differential housing; to do so, place housing on thrust plate -
VW 401- and thrust plate -VW 402- .
Note
Hold flange shaft -A- with one hand to prevent it from falling.
– Pry out oil seal.
Note
To prevent damage to the housing, place something underneath
(e.g. metal bar -A-).
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
⇒ page 158 .
⇒ page 158 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Servicing transfer box
161