Audi A8 Workshop Manual page 32

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Take clutch „B" -item 1- out of gearbox.
– Detach axial needle bearing -4- from top of clutch „B"
-item 3-.
– Turn clutch „B" upside down.
– Using two small screwdrivers, unclip axial needle bearing -2-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
from clutch „B" -item 3-.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
Make sure that the axial needle bearing is unclipped complete
with the bearing cage and thrust washer.
– Detach rectangular section seals -1- from sun gear shaft of
body „II".
– Detach flange washer -1- from clutch „C/D".
– Remove circlip -arrow- for body „I".
Note
The circlip must be re-used; take care not to over-stretch it on
removal.
28
Rep. gr.37 - Controls, housing