Audi A8 Workshop Manual page 60

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
WARNING
Wear safety goggles.
– Carefully press piston „D" out of cylinder „C/D" using com‐
pressed air.
Assembling
Caution
Check components of piston/cylinder „D" for traces of wear and
damage ⇒ „3.3 Clutch D ", page 167
– Renew O-ring -2- for cylinder „C/D" -item 1-.
– Renew O-ring -3- in piston „D" -item 4-.
– Fit piston „D" -item 4- into cylinder „C/D" -item 1-.
– Renew O-ring -2- for cylinder „C/D" -item 1-.
• The O-ring is fitted in the 2nd groove from the top.
– Renew O-ring -3- for retaining plate -4-.
– Insert retaining plate -4- into cylinder „C/D" -item 1-.
• The cast lug on the retaining plate must be located opposite
the recess on cylinder „C/D" -arrows-.
– Insert split retaining ring -5-.
• The upward-pointing retaining lugs must fit in the recess on
cylinder „C/D"
56
Rep. gr.37 - Controls, housing
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.