Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Caution
Before fitting the plates of clutch „D", you must first adjust the
clearance of clutch „D" by determining the thickness of the thick
outer plate for clutch „D"
– Install thick outer plate for clutch „D" of the required thickness
-item 4-.
– Fit friction plates -3- and outer plates -2- alternately.
– Insert corrugated spring -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Clip axial bearing -2- onto cylinder „C/D" -item 1-.
– Check whether parallel keys -arrow- are fitted centrally on both
sides of cylinder „C/D".
– Turn clutch „C/D" -item 1- upside down and fit clutch in gearbox
housing.
•
The oil drillings -arrows- on cylinder „C/D" face towards the
ATF oil pan end.
– Carefully insert circlip -arrow- for body „I" into gearbox hous‐
ing.
Note
The circlip must be re-used; take care not to over-stretch it when
installing.
– Make sure that circlip locates securely in groove of gearbox
housing; knock circlip into groove all round with a punch if
necessary.
32
Rep. gr.37 - Controls, housing
⇒ page 57
.