Audi A8 Workshop Manual page 104

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Unscrew securing bolts for mechatronic unit in reverse order
(i.e. first bolt -11-, then -10-, ... etc. until -1-).
Note
Loosen only the securing bolts indicated in the illustration
♦
-1 ... 11-.
If other bolts are loosened, this may affect the operation of the
♦
mechatronic unit or the mechatronic unit could come apart.
– Remove mechatronic unit together with wiring harness from
gearbox, at the same time guide out connector for wiring har‐
ness.
Installing
Installation is carried out in reverse sequence; note the following:
Tightening torques ⇒ page 91
– Make sure that seal -B- is properly inserted and secured.
– Clip wiring harness -A- onto mechatronic unit -B-. To do so,
first attach tab -arrow- on reverse side of wiring harness to
mechatronic unit.
Note
If the tab on the reverse side of the wiring harness breaks off, the
wiring harness must be renewed.
100
Rep. gr.38 - Gears, control
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.