Audi A8 Workshop Manual page 30

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Detach adapter -B- for mechatronic unit.
– Pull out gasket -A- for ATF strainer (if it has not already been
removed together with the ATF strainer).
– Pull out a total of four aluminium sleeves -1-.
Caution
The sealing sleeves -2- are of different lengths: note the orig‐
inal positions for re-installation.
– Pull out a total of four sealing sleeves -2- using extractor tool
-T10271- .
– Turn gearbox on assembly stand.
• The torque converter must face upwards.
– Slacken bolts for ATF supply unit in the sequence -14 ... 1-
and remove bolts.
– Remove bolts with sealing washers.
– Apply puller for ATF supply unit -T40123- to stator shaft.
– Detach ATF supply unit.
Note
If necessary, release ATF supply unit by tapping gently with a
rubber-headed hammer.
– Detach O-ring from ATF supply unit.
26
Rep. gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.