Audi A8 Workshop Manual page 105

– Renew O-rings on connector for wiring harness and lightly lu‐
bricate with ATF.
– Install wiring harness connector in gearbox housing.
• Lugs -1- and -2- on collar are horizontal, flat section -arrow- of
connector faces inside of gearbox.
– Install mechatronic unit without using force, and at the same
time fit pin on gearbox selector lever -arrow- into slot on se‐
lector slide -A- (move selector slide backwards and forwards
if necessary).
– Tighten securing bolts -1- and -2- for mechatronic unit to 2 Nm.
– Tighten securing bolts for mechatronic unit in specified order
to specified torque (i.e. first bolt -1-, then -2-, ... etc. until
-11-).
– Push retainer clip -arrow- onto wiring harness connector.
– Install ATF strainer ⇒ page 97
– Install oil pan ⇒ page 93
– Fill up with ATF ⇒ Automatic gearbox 09E, four-wheel drive;
Rep. gr. 37 ; Draining ATF and filling up after repairs .
• If mechatronic unit was renewed:
– Perform gearbox adaption after gearbox is installed in vehicle
⇒ page 15 .
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.
Audi A6 2005 ➤ , Audi A8 2003 ➤
1. Oil pan, ATF strainer and mechatronic unit - exploded view
101