Audi A8 Workshop Manual page 117

– Pull ATF strainer -arrow- off mechatronic unit.
– Detach retaining clip -arrow- for wiring harness connector and
push connector inwards.
– Remove bolts -arrows A and B-.
Caution
♦ Loosen ONLY the bolts with the larger bolt heads
-arrows A- and -arrows B-.
♦ If other bolts are loosened, this may affect the operation
of the mechatronic unit or the mechatronic unit could come
apart.
♦ Observe different bolt lengths.
– Lift mechatronic unit slightly and pull wiring harness connector
out of gearbox housing.
Caution
To avoid damaging the senders on the rear of the unit, always
put down the mechatronic unit so that the side with the bolt
heads faces downwards.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Dismantling and assembling ATF supply unit
113