Audi A8 Workshop Manual page 35

Assembling
Note
When installing body „I", the complete planetary drive „II" and „III"
is first installed without clutch „C/D" and without the plates of
clutch „D".
– Fit flange washer -2- on planetary drive „II" and „III" -item 1-.
• The flange on the rim of the flange washer faces upwards.
– Screw threaded spindle -1- of lifting device -T10272- into tap‐
ped hole of planetary drive „II" and „III" as far as stop.
– Secure planetary drive „II" and „III" on lifting device by screw‐
ing sleeve -2- on threaded spindle by hand all the way down.
– Connect eye of lifting device -T10272- to workshop hoist -VAS
6100- by means of shackle -10 - 222 A/12- .
– Turn gearbox on assembly stand.
• The torque converter must face upwards.
– Lift planetary drive „II" and „III" off support -T40118- .
– Lower planetary drive „II" and „III" into gearbox housing using
workshop hoist -VAS 6100- .
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Dismantling and assembling planetary gearbox
31