Audi A8 Workshop Manual page 148

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Installation depth:
If the torque converter has been correctly installed, the distance
-a- measured between the surface of the mounting holes and the
contact surface of the torque converter bellhousing should be:
• 8 or 12-cylinder petrol engines: at least 5.9 mm
• 10-cylinder petrol engines and 8-cylinder TDI engines: at least
18.9 mm
Caution
If the torque converter is not fitted correctly, the torque con‐
verter drive lugs or the ATF pump will be irreparably damaged
when the gearbox is joined to the engine.
– Install flange shaft (left-side)
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Caution
♦ Make sure that the bearing races and shims for the differ‐
ential do not drop out of the gearbox housing and the front
final drive cover.
♦ Bearing races and shims cannot be re-allocated to their
original positions by the workshop if they have dropped
out.
– Clean magnet -1- on rear side of baffle plate.
– Ensure that magnet makes full contact with baffle plate.
– Renew seal -2- for breather passage.
– Tighten bolts for baffle plate -arrows-.
• Tightening torque: 8 Nm.
144
Rep. gr.39 - Final drive - front differential
⇒ page 128 .