Audi A8 Workshop Manual page 108

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Install mechatronic unit without using force, and at the same
time fit pin on gearbox selector lever -arrow- into slot on se‐
lector slide -A- (move selector slide backwards and forwards
if necessary).
– Tighten securing bolts -1- and -2- for mechatronic unit to 2 Nm.
– Tighten securing bolts for mechatronic unit in specified order
to specified torque (i.e. first bolt -1-, then -2-, ... etc. until
-14-).
– Clip wiring harness -B- onto mechatronic unit. To do so, first
attach tab -arrow- on reverse side of wiring harness to me‐
chatronic unit.
Note
If the tab on the reverse side of the wiring harness breaks off, the
wiring harness must be renewed.
– Carefully insert connector -C- in connector socket on mecha‐
tronic unit.
The remaining installation steps are carried out in reverse se‐
quence; note the following:
– Install ATF strainer ⇒ page 97
– Install oil pan ⇒ page 93
– Fill up with ATF ⇒ Automatic gearbox 09E, four-wheel drive;
Rep. gr. 37 ; Draining ATF and filling up after repairs .
• If mechatronic unit was renewed:
– Perform gearbox adaption after gearbox is installed in vehicle
⇒ page 15 .
104
Rep. gr.38 - Gears, control
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.