Audi A8 Workshop Manual page 121

– Apply puller for ATF supply unit -T40123- to stator shaft.
– Fit ATF supply unit in gearbox housing again (turn ATF supply
unit slightly in both directions).
• The opening on the housing of the ATF supply unit faces to‐
wards the ATF oil pan end.
– Detach puller for ATF supply unit -T40123- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Fit new sealing washers on bolts for ATF supply unit.
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Tighten bolts for ATF supply unit in sequence -1 ... 14-.
• Tightening torque: 10 Nm
– Check axial clearance of input shaft again
If reading again does not match specification:
– Repeat adjustment.
If result matches specification:
– Turn gearbox on assembly stand.
• The ATF oil pan must face upwards.
– Make sure that sealing sleeves -2- and aluminium sleeves
-1- are fitted.
Caution
Observe different lengths of sealing sleeves; they should be at
the same height when installed.
– Renew seals on adapter -B-.
– Install adapter for mechatronic unit.
Note
Item -A- can be disregarded.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
⇒ page 116
Audi A6 2005 ➤ , Audi A8 2003 ➤
.
2. Dismantling and assembling ATF supply unit
117