Removing And Installing Air Cleaner Housing - Audi A8 2010 Workshop Manual

Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
– Clean salt residue, dirt and leaves out of air cleaner housing
(top and bottom sections) using a vacuum cleaner.
– Blow out water drain -arrow- at air cleaner (bottom section)
with compressed air.
– Check for dirt and leaves in air duct going from lock carrier to
air cleaner housing.
– When installing air filter element, check that it is properly cen‐
tred in retainer in air cleaner (top section).
– Turn air filter element in clockwise direction -arrow B- so that
it engages.
– Carefully fit top section of air cleaner onto bottom section,
without using any force.
– Make sure that air hose is securely fitted on air cleaner (top
section).
Remaining installation steps are carried out in reverse sequence;
note the following:
– Install longitudinal member (top right) ⇒ Rep. gr. 50 .
– Install lock carrier cover ⇒ Rep. gr. 63 .
2.6 Removing and installing air cleaner
housing
Removing
– Remove lock carrier cover -2- ⇒ Rep. gr. 63 .
20
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.