Audi A8 Workshop Manual page 63

– Using digital depth gauge -VAS 6087- , measure projection of
piston „D" -item 2- above cylinder „C/D" -item 1-.
– Make a note of dimension -d-.
– Assemble plates of clutch „D" -item 1- in correct sequence,
without thick outer plate, on compressor tool -T10285- .
• The last friction plate is fitted at the top.
• The corrugated spring is at the bottom.
– Place holding plate -T10281- onto last friction plate.
• The holding plate should be positioned centrally on the friction
plate.
– Fit centring pin of thrust piece -T10285/1- into drilling in holding
plate.
– Position plates of clutch „D" -item 1- so they are aligned exactly
one above the other on base plate of compressor tool.
• Thrust piece must be positioned centrally below thrust plate of
spindle.
– Turn spindle of compressor tool downwards.
• The markings on the inspection hole of the thrust piece must
align -arrow-.
– Apply digital depth gauge -VAS 6087- to outer rim of top friction
plate as shown in illustration.
– Measure height of plates -1- of clutch „D" above base plate of
compressor tool in compressed condition.
• Height of clutch pack in compressed condition (not including
thick outer plate) = dimension -f-
– Make a note of dimension -f-.
– Repeat measurement at two further points on top friction plate,
offset by 120° each time.
– Determine average value from the three measurements under
load.
– Release spindle and remove holding plate.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
3. Dismantling and assembling body „I"
59