Audi A8 Workshop Manual page 127

– Remove ATF pump gears -3- and -4- from ATF pump housing
-2-.
1 - O-ring
Installing
Caution
Check the individual components of ATF supply unit for traces
of wear and damage ⇒ page 178
– Renew O-ring -1- on ATF pump housing.
– Insert ATF pump gears -3- and -4- into ATF pump housing
-2-.
• The dots on the ATF pump gears face upwards.
– Screw in M6 guide pins -T10288/4- .
– Install ATF pump unit into the ATF supply unit housing.
– Tighten bolts -arrows 1- and -arrows 2- diagonally in stages.
• Tightening torque: 10 Nm
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Dismantling and assembling ATF supply unit
123