Audi A8 Workshop Manual page 79

– Detach inner plate carrier „A" -item 3- from clutch „A"
-item 1- and clutch „E" -item 2-.
– Turn inner plate carrier „A" -item 1- upside down and remove
axial needle bearing -2-.
Note
Use a scriber if necessary to unclip bearing.
– Detach inner plate carrier „E" -item 6- with intermediate shaft
from clutch „E" -item 4-.
– Unclip axial needle bearing -5- from clutch „E" -item 4-.
– Detach clutch „E" -item 4- from clutch „A" -item 1-.
– Unclip axial needle bearing -3- from clutch „E" -item 4-.
Note
Use a scriber if necessary to unclip bearing.
– Remove oil collector -2- from planet carrier „I" in clutch „A"
-item 1-.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
5. Dismantling and assembling body „II"
75