Audi A8 Workshop Manual page 73

– Turn cylinder „B" upside down.
WARNING
Wear safety goggles.
– Carefully press piston „B" together with retaining plate out of
cylinder „B" using compressed air (cover oil drilling on opposite
side with your finger).
Assembling
Caution
Check components of clutch „B" for traces of wear and damage
⇒ „3.5 Clutch B ", page 171
– Renew O-rings -2- and -3- for piston „B" -item 4-.
– Renew O-ring -5- for retaining plate -6-.
– Push piston „B" -item 4- into cylinder „B" -item 1- as far as stop.
– Insert retaining plate -1-.
– Press retaining plate downwards slightly by hand or using two
screwdrivers -arrow-.
– Insert circlip -2-.
– Fit dished spring -2- and retaining ring -3- on cylinder „B"
-item 1-.
• The smooth side of the retaining ring faces the dished spring.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
4. Dismantling and assembling clutch „B"
69