Removing And Installing Mechatronic Unit - Gearbox With 13 Bolts On Oil Pan - Audi A8 Workshop Manual

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
1.4 Removing and installing mechatronic
unit - gearbox with 13 bolts on oil pan
Removing
Note
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 11
General repair instructions
♦
Always renew mechatronic unit if contaminated or defective.
♦
– Remove oil pan ⇒ page 93
– Remove ATF strainer
Caution
The gearbox control unit (mechatronic unit) can be damaged
by electrostatic discharge.
♦ Before touching or removing the mechatronic unit, always
discharge any static electricity by touching vehicle earth
or other earthed object with your hand.
♦ DO NOT touch contacts in 16-pin connector with your
hands, as static discharge can seriously damage the con‐
trol unit and mechatronic unit.
– Touch vehicle earth or gearbox housing with your hand (with‐
out gloves) to discharge any static electricity.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Note
with respect to the correctness of information in this document. Copyright by AUDI AG.
Wiring harness -B- with connector -C- must be disconnected from
the mechatronic unit before removing the mechatronic unit. The
wiring harness connector remains in the gearbox housing.
102
Rep. gr.38 - Gears, control
⇒ page 1 .
.
⇒ page 97 .