Audi A8 Workshop Manual page 125

– Check that there are no burrs or sharp edges on gearbox end
of flange shaft (left-side) -arrow-; deburr edges if necessary.
– Clean flange shaft (left-side) and oil seal between final drive
and gearbox housing.
– Pack space between sealing lips -arrow- of oil seal half-full
with sealing grease -G 052 128 A1- .
Caution
While inserting the flange shaft (left-side), it must be held cen‐
trally to avoid damaging the oil seal between the final drive and
the gearbox housing.
– Insert flange shaft -A- (left-side) into gearbox, guiding shaft
centrally into oil seal between final drive and gearbox housing
-arrow-.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Dismantling and assembling ATF supply unit
121