Clutch „C - Audi A8 Workshop Manual

3.2 Clutch „C"
3 - Friction plate
❑ Checking for wear
⇒ page 165
4 - Outer plate
❑ Checking for wear
⇒ page 165
10 - Piston„C"
❑ Check for wear
12 - Cylinder „C/D"
❑ Check running surface
of piston „D" for scoring
by friction plates
⇒ page 166
❑ Checking bearing bush
for wear ⇒ page 166
Checking friction plates and outer plates for wear
Signs of overheating on the outer plates indicate that the friction
plates are worn. Assess the degree of wear as described below:
A - Heat discoloration spots at intervals of more than 20 mm: outer
plates and friction plates are OK; they can be used again.
B - Heat discoloration spots at intervals of less than 20 mm: outer
plates and friction plates are worn and require renewal.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
C - If outer and/or inner parts of outer plates are discoloured blue
with respect to the correctness of information in this document. Copyright by AUDI AG.
or brown: outer plates and friction plates are worn and require
renewal.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Audi A6 2005 ➤ , Audi A8 2003 ➤
3. Assessment of wear on gearbox components
165