Audi A8 Workshop Manual page 146

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Slide magnet -arrow- into gearbox housing, as shown in illus‐
tration.
– Install intermediate pinion for front axle drive -1- with input
shaft.
– Fit shims -2- and -3-.
– Check that dowel sleeve -1- is fitted.
– Renew gasket for intermediate flange for front axle drive.
– Fit intermediate flange for front axle drive on gearbox housing.
• The pump drive coupling -3- must engage in the hexagon in
the side shaft -2-.
– Tighten bolts on intermediate flange for front axle drive in two
stages as follows:
Stage
1 – Pre-tighten bolts to 5 Nm in sequence -1 ... 4-.
2 – Tighten bolts to 30 Nm in sequence -1 ... 19-.
142
Rep. gr.39 - Final drive - front differential
Tightening sequence
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.