Audi A8 Workshop Manual page 122

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Renew O-rings for wiring harness connector.
– Fit wiring harness connector in gearbox housing.
• Lugs -1- and -2- on collar are horizontal, flat section -arrow- of
connector faces inside of gearbox.
– Fit retaining clip -arrow- for wiring harness connector.
– Place mechatronic unit in position on gearbox housing without
using force. At the same time insert pin -2- of detent plate so
that it engages in slot on selector slide -1-.
– Screw in bolts -arrows- hand-tight.
Note
Note different bolt lengths. Allocation:
Location Quantity Bolt length
-Arrow A- = 7
-Arrow B- = 4
118
Rep. gr.38 - Gears, control
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
M6x50
M6x20