– Install bolts for cover for front final drive (observe specified
tightening torque and sequence)
– Install flange shaft (right-side)
1.7
Renewing oil seals for side shaft - gear‐
box with separate oil systems
Procedure
Note
General repair instructions
♦
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 11
•
Gearbox removed
•
Secure gearbox to assembly stand
•
The gearbox must be horizontal with the ATF oil pan facing
downwards.
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
– Remove ATF drain plug -arrow A- and allow ATF to drain off.
Note
Observe relevant disposal regulations.
♦
Some ATF always remains in the oil pan.
♦
-Arrow B- can be disregarded.
♦
– Remove drain plug -C- and allow gear oil to drain out of trans‐
fer box.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
⇒ page 127
.
⇒ page 127
.
⇒ page 1
.
⇒ page 18
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
1. Servicing front final drive
135