Audi A8 Workshop Manual page 154

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Renew sealing sleeves -4- and -5-.
– Check that dowel sleeves -1- and -3- are fitted.
– Hold protective tube -2- for side shaft in position.
– Stick conical washer -1- onto end of pinion shaft -2- using a
small amount of grease.
– Fit torque converter bellhousing on gearbox and tighten bolts
-1 ... 18- diagonally in stages.
• Tightening torque: 23 Nm
– Renew securing bolt for side shaft.
– Insert securing bolt through washer in side shaft and apply
17 mm socket with approx. 350 mm extension to bolt.
– With socket applied, insert side shaft into gearbox.
– Counterhold with hexagon wrench -T40124- and 27 mm open-
end spanner -item 1-.
– Tighten securing bolt for side shaft in five stages as follows:
Stage
1 – Tighten bolt to 60 Nm.
2 – Slacken bolt.
3 – Tighten bolt to 60 Nm once again.
4 – Slacken bolt.
5 – Tighten bolt to 77 Nm.
150
Rep. gr.39 - Final drive - front differential
Tightening sequence
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.