Audi A8 Workshop Manual page 80

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Place clutch „A" with planet carrier „I" -item 2- on workbench.
– Release circlip -1- on inside of planet carrier „I" -item 2- at a
total of four points using a small screwdriver.
Note
Aim a torch (flashlight) between the planetary gears to find the
♦
points where you can press against the circlip.
Pull planet carrier „I" evenly off clutch „A" as you release the
♦
circlip to prevent the points that have already been released
from re-engaging.
– Detach planet carrier „I" -item 2- and turn it upside down.
– Remove circlip -4- from groove in planet carrier „I" -item 1-.
– Take sun gear „I" -item 3- and axial needle bearing -2- out of
planet carrier „I" -item 1-.
Note
Ignore -item A- and -item B-.
76
Rep. gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.