Displaying An Active Programmable Work Offset - Siemens SINUMERIK 840Di sl Operating Manual

5
Parameters operating area
5.6 Zero/work offset

5.6.5 Displaying an active programmable work offset

Work
Go to...
offset
Active
progr. WO
5-236
The following values are displayed:
• Actual value of MCS and settable zero system
• Overlaid movements
• DRF offsets
• Zero offsets external
• Sum of the work offsets; calculated from the basic, settable and
programmable work offsets (corresponds to the "Editing the
active..." table)
• Data of the active tool (T number, D number with reference to the
plane G17, lengths, radius)
• WCS actual value.
Additional information
The active work offset must be changed only when the NC program is
stopped. Changes are updated immediately. The work offset values in
the display are updated cyclically.
Function
The active, selected programmable work offsets (from part program or
MDI) can be displayed.
Values cannot be edited in this display.
Sequence of operations
Press the "Work offset" and "Go to ..." softkeys.
The vertical softkey bar changes.
The "Active progr. WO" window opens.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
© Siemens AG 2008 All rights reserved.