Display Tool - Siemens SINUMERIK 840Di sl Operating Manual

5
01/2008

5.2.3 Display tool

Tool
offset
T-No. T-No.
+ -
© S iemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Function
You can select tools that you have created and access their tool offset
data.
Sequence of operations
The "Tool offset" window is displayed automatically.
If the "Parameters" area has already been selected, the window and
the last tool selected when the area was exited are displayed.
The tool offset data of the current tool are displayed immediately. If no
tool has yet been selected, the data of the first tool are shown
together with its first D number.
If no tools are available in the area, a message is output.
Select the created tools.
Additional information
Input of the geometry and wear data of the tool can be disabled using
the keylock switch.
Parameters operating area
5.2 Tool offset
5
5-177