Siemens SINUMERIK 840Di sl Operating Manual page 321

6
01/2008
Menu "Match data"
vertical
Loaded
data
Compare
setup data
Compare
tools
Compare
mach. data
Compare
cycles
<<
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
simulation interpreter), must be jumped conditionally in the
corresponding NC program with evaluation of system variable
$P_SIM during the simulation (..IF $P_SIM GOTOF label). The
components relevant to simulation (e.g. tool change position and M
switching functions for tool change in tool change cycles, etc.
cannot be skipped, they must be executed.
5. The simulation does not evaluate events set by MD 20108, which
lead to program activation.
Correct password and NC components are prerequisite for using
Match data to load data selected in the NC to the simulation
environment. The data is then available for the simulated programs
just like during program execution in the NC.
(Matched data see data management \DP.DIR\SIM.DIR)
The loaded files are displayed.
User programs, user cycles, standard cycles, manufacturer
cycles and base data.
The selected data is loaded into the simulation environment from the
NC.
After editing NC data, a new data synchronization operation must be
performed.
On the other hand, the response of the NC to modified data can be
simulated in advance by editing the data within the simulation
environment.
The tool data for all channels is loaded to the simulation environment
and copied to the file TO_INI.INI.
The machine data and active definition files are loaded to the
simulation environment and copied to the file INITIAL.INI.
The cycles which have already been loaded into the simulation are
replaced by cycles with more recent time stamps.
Return to main simulation menu.
"Program" operating area
6.8 Program simulation
6
6-321