Siemens SINUMERIK 840Di sl Operating Manual page 169

5
01/2008
Calculation of tool base
dimensions for two-
dimensional millhead
© S iemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Tool base dimension/ Length compensations
adapter
21 Length 1
22 Length 2
23 Length 3
Technology
24 Clearance angle
25 Clearance angle
Offsets that are not required must be assigned the value 0 (= default
when the offset memory is set up).
The individual values of the offset memory (P1 to P25) can be read
and written by the program via system variables.
The tool offsets can be entered not only via the operator panel front
but also via the data input interface.
DP1
DP3
DP6
Parameters operating area
5.1
For turning tools
Length 1
reference point
reference point
5
Tool data
Y
Y
Y
5-169