General Functions And Displays; Start/Stop/Abort/Continue Part Program - Siemens SINUMERIK 840Di sl Operating Manual

4
Machine operating area
4.2

General functions and displays

4.2

General functions and displays

4.2.1 Start/stop/abort/continue part program

Prerequisite
Cycle Start
Cycle Stop
Reset
Machine
JOG
Repos
+X X
...
4-94
Function
The following section describes how to start and stop part programs
and to resume them after they have been aborted.
Sequence of operations
"AUTO" mode is selected in the "Machine" operating area.
No alarms are pending.
The program is selected.
Feed enable is active.
Spindle enable is set.
Start part program:
The part program is started and executed.
Stop/abort part program:
The program run is interrupted, but can be restarted with
"NC Start".
The current program is aborted.
Continue part program:
After interrupting the program ("NC Stop") you can retract the tool
from the contour in the mode ("JOG"). The control saves the
coordinates of the point of interruption. The distances traversed are
displayed.
Repositioning:
Select the "Machine" operating area.
Select "JOG" mode.
Press the "Repos" key to reposition the tool on the contour.
Turning machine:
Press the "+X" or "-X" key.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
4
01/2008
© Siemens AG 2008 All rights reserved.