Siemens SINUMERIK 840Di sl Operating Manual page 301

6
01/2008
Broken-line graphics
Chamfers and rounding
Example
Maximum contour size
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
In broken-line graphics, the contour is displayed with starting and end
points. The cloned elements are marked without starting and end
points. In addition, the lines of symmetry are displayed with dashed
lines. In program overview, the entire contour is displayed without
starting and end points and without lines of symmetry.
When mirroring, the contour is reflected in the starting or end point. A
chamfer or rounding can be added at this stage.
During repetition, the open contour is cloned to create a closed
contour. The number N shows how many parts are required to create
the closed contour. A chamfer or rounding can be added between
these parts. The direction of rotation for closing can be freely selected.
Behavior of chamfers and rounding
The maximum number of contour elements is limited to 250.
Contour * Mirroring (1 or 2) * Repetition (N) ≤ 250 Elements
"Program" operating area
6.7 Free contour programming
20
R1
R5
100
6
6-301