Siemens SINUMERIK 840Di sl Operating Manual page 315

6
01/2008
ASCII editor link
References
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
After deliberate interruptions (simulation STOP or Single-block in the
main simulation menu) or on alarms, you can use the "Correct
program" softkey to open the program in the editor at the point of
interruption. For interruptions within protected cycles the program
pointer is positioned at the line with the corresponding subprogram
call.
If changes are made in the editor, simulation is returned to the last
active section (intermediate model if available).
Additional information
1. The integrity of the simulation data (programs, subprograms, tool
data, etc.) is assured by systematic time-stamp evaluation for all
loading operations.
2. NC language labels (e.g. WAIT2: WAITM...) ...) programmed to
identify particular points in the program, can be inserted in the
simulation graphic as path labels. You can simultaneously
initiate the generation of intermediate models at these points in the
program (see "Manage settings\Display and colors...\Manage path
labels").
3. The model used is based on a 3D Cartesian model.
4. The software limit switches are not evaluated during the simulation
because no reference point approach is performed. Even an entry
in the DPSIM.TEA file is not taken into account.
DPSIM.TEA is used to adjust machine data which the user may have
defined incorrectly in the INITIAL.INI.
For a detailed description please refer to:
Function Manual Basic Functions, Interactive Programming (D2)
"Program" operating area
6.8 Program simulation
6
6-315