Siemens SINUMERIK 840Di sl Operating Manual page 193

5
01/2008
Edit tool data
Cutting
edge data
Monitoring
data
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
A new cutting edge can be added to a tool at any time (even if the tool
is already located in the magazine). Select "New cutting edge" and
enter the cutting edge data.
Press the "Cutting edge data", "Mon. data" and "Local offsets"
softkeys to display tables for editing the respective data. You can
move freely between the individual tables. The name, Duplo number
and type of tool and all defined cutting edges (#1...#12) are displayed.
Use the "Cutting edge +" and "Cutting edge -" softkeys to toggle
between the cutting edges. Press "<<" to return to the "Tool details"
input screen.
Note
When you edit the data, the new data is saved immediately. The "<<"
softkey only changes the display.
The cutting edge data and tool offsets of the currently selected cutting
edge are displayed and can be edited.
You can edit the following data:
• Cutting edge user data (OEM_Sx; x = 1...10)
• Tool offsets
− Geometry
− Wear
− Basic offset
− Cutting edge position (for turning tools)
− Tool clearance angle (for turning tools)
You can define the value of Length1, Length2, Length3 and Radius1
for every parameter.
The monitoring data of the currently selected cutting edge are
displayed and can be edited.
When you have selected a cutting edge, define the actual value,
setpoint and warning limit monitoring data for the following
parameters:
• Quantity
• Tool life
• Wear
Parameters operating area
5.3 Tool management
5
5-193