Siemens SINUMERIK 840Di sl Operating Manual page 407

8
01/2008
"Connection +" softkey
"Connection −" softkey
"General" softkey
"Send connection"
softkey
"Receive connection"
softkey
"Display
SPL connection" softkey
"Display connection"
softkey
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
• Driver state
Status code:
[0] "Not initialized"
[1] "Establish communication after booting"
[2] "Establish communication after error"
[3] "Wait for checkback signals SN=1"
[4] "Receiver waits for user acknowledgement"
[5] "Normal operation"
Vertical softkeys:
Changes to the next send connection (F_SENDDP).
If less than 2 connections are configured, then this softkey is not
displayed.
Changes to the previous send connection (F_SENDDP).
If less than 2 connections are configured, then this softkey is not
displayed.
Displays the "SI communication (general)" dialog box.
This means that you change to the "SI communication (send)" dialog
box.
This means that you change to the "SI communication (receive)"
dialog box.
This means that you change to the "Details, SPL connection (send)"
dialog box.
This softkey can only be selected if send connections have been
configured.
This means that you change to the "SI communication (send)" dialog
box.
Diagnostics operating area
8.4 Service displays
8
8-407