Siemens SINUMERIK 840Di sl Operating Manual page 345

6
01/2008
References
References
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
3. /CUS.DIR / name.type User cycles
4. /CMA.DIR / name.type Manufacturer cycles
5. /CST.DIR / name.type Standard cycles
Case 2: When a subprogram is called by
name without specification of the data type ("identifier" or
"extension"),
e.g. SHAFT1
the system searches through the directories in the following sequence:
1. Current directory / name
2. Current directory / name.SPF
3. Current directory / name.MPF
4. /SPF.DIR / name.SPF
5. /CUS.DIR / name.SPF
6. /CMA.DIR / name.SPF
7. /CST.DIR / name.SPF
/PGA/, Programming Guide Advanced
Machine manufacturer
see the machine manufacturer's information.
Preconditions:
- A main program (MPF) in the workpiece directory is
selected
"NC Start" was activated
$MN_WPD_INI_MODE=0:
The INI file with the same name as the selected workpiece is
executed.
For example, if SHAFT1.MPF is selected, SHAFT1.INI is
executed when "NC Start" is pressed.
(Behavior as with previous software versions)
$MN_WPD_INI_MODE=1:
All files of type INI, SEA, GUD, RPA, UFR, PRO, TOA,
TMA and CEC which have the same name as the selected main
program are executed in the specified sequence.
• The main programs stored in a workpiece directory can be
selected and processed by several channels.
Commissioning Manual HMI-Advanced (IM4)
"Program" operating area
6.9 Managing programs
Workpiece/standard
directory MPF.DIR
Subprograms
User cycles
Manufacturer cycles
Standard cycles
6
6-345