Siemens SINUMERIK 840Di sl Operating Manual page 168

5
Parameters operating area
5.1 Tool data
Calculation of tool
parameters
5-168
Types 1xx (milling cutters), 2xx (drills) and 5xx (turning tools) are
calculated according to the same scheme.
Several entries exist for the geometric variables (e.g., length 1 or
radius). These are added together to produce a value (e.g., total
length 1, total radius), which is then used for the calculations.
Tool parameter Significance
number (P)
1 Tool type
2 Length of cutting edge only for turning tools
Geometry Length compensation
3 Length 1
4 Length 2
5 Length 3
Geometry Radius
6 Radius
7 Reserved
8 Reserved
9 Reserved
10 Reserved
11 Reserved
Wear Length and radius compensation
Radius compensation
12 Length 1
13 Length 2
14 Length 3
15 Radius
16 Reserved
17 Reserved
18 Reserved
19 Reserved
20 Reserved
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
01/2008
Comment
For overview see list
Calculation according to type and
plane
Does not apply to drills
© S iemens AG 2008 All rights reserved.
5