Tool Management - Siemens SINUMERIK 840Di sl Operating Manual

5
Parameters operating area
5.3

Tool management

5.3

Tool management

Magazine list
Tool list
Working offset list
5-182
The tool management system is organized by means of various
configurable lists which show different views of the tools used.
In the "Magazine list", the tools of a magazine are displayed in order
of ascending magazine location numbers.
You can search for, display and, in the majority of cases, edit the data.
A function is also provided for checking the D numbers and
subsequently activating tools.
This list is mainly used to load and unload tools during setup, and to
move tools between magazines.
In the "Tool list", the tools are displayed in the order of ascending T
numbers.
You use this list if you are working with small tool magazines and
know the exact magazine location of each tool.
The cutting edges of active replacement tools are displayed in the
"Working offset list". They are sorted in order of ascending D
numbers.
You can search (according to D number/DL
the data.
Notice
Use this list to edit and monitor sum offsets (local offsets), quantities
and cutting edge parameters during the machining process. You can
configure up to three different views for the working offset list.
The TOA is assigned to multiple channels and is effective in the
channel in which the tool is active. If you want to change the wear in
the list of working offsets without having to call the tool again at the
next NC Start, ensure that the correct channel is selected for this tool.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
, display and edit
number)
© Siemens AG 2008 All rights reserved.