Siemens SINUMERIK 840Di sl Operating Manual page 320

6
"Program" operating area
6.8 Program simulation
Fit to
size
Zoom...
<<
Menu Alarm "Details...."
vertical
End
simulation
Details
view...
<<
6-320
Automatic screen size adaptation
Also possible using the "ENTER" or "INPUT" key.
Show window pane border in active window
(Size can be altered with "+" - and "-" keys, position can be altered
with cursor keys.)
</ph>
Return to main simulation menu
Assuming an alarm status during simulation,
independent of the view currently active
Reset POWER ON alarms of simulation. The simulation is terminated
and loaded again.
Reset RESET alarms of simulation. The simulation interpreter is reset.
The simulation can be started again.
Reset CANCEL alarms of simulation. The simulation can be
continued.
The simulation process is terminated. A load operation is necessary
before the simulation is selected again.
Open the menu bar corresponding to the active workpiece view
"Details..." (standard or 3D) from the alarm state. The simulation
alarms remain active.
Return to main simulation menu
Additional information
1. Simulation alarms are only messages of the simulation
interpreter and have no direct association with the current
NCK machining status on the machine tool.
2. If more than one simulation alarm is pending, you can show or hide
the complete alarm list with the "toggle" key. You can select an
alarm with the "cursor" keys.
3. If you press the information key "
explanation of the selected alarm is displayed.</F>
4. Program sequences which cannot be interpreted in simulation
contexts only and only then trigger an alarm (e.g. in user cycles
because the relevant PLC data and signals are not available in the
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
01/2008
i
" the online help with an
© Siemens AG 2008 All rights reserved.
6