Siemens SINUMERIK 840Di sl Operating Manual page 189

5
01/2008
Delete tool
Tool in
cabinet
Data on CC
in cabinet
Abort
OK
New
tool
<<
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
The selected tool is removed from the list. Use the vertical softkeys to
determine whether to save the tool data.
The data are copied into the tool cabinet. The tool can be loaded later
with the same data.
If a code carrier is installed, the tool data are stored on the carrier. The
tool can then be loaded later with the same data.
The operation is canceled. The tool is not removed from the list.
The tool is deleted from the list. The tool data are no longer available.
Each time you press this softkey, a tool is created immediately. The
screen form for entering the tool data (tool details) and the associated
softkey bar (same as tool details) appear. The values are initialized
with the default settings (configured in the INI file) and can be edited
here (e.g., you can change the name of the tool).
Use the vertical softkey bar to display the tables for cutting edge data
and offsets with the default settings. If necessary, enter any changes
in the individual views.
Terminates input of the tool data and switches to the tool list display.
The new tool appears in the table and is available for loading.
Once you have set up a new tool, the cursor automatically jumps to
the line containing the new tool when you return to the tool list. This
gives you feedback about your operation.
Parameters operating area
5.3 Tool management
5
5-189