Program Control Display - Siemens SINUMERIK 840Di sl Operating Manual

2
Operator Components/Operating Sequences
2.4 Screen layout

2.4.3 Program control display

SKP
Skip block
SKPn
SBL1
Single block with STOP after
each machine function block
SBL2
Single block with stop after
each block
SBL3
Stop in cycle
2-48
Function
Functions that have been activated are visible in the program control
display (can be set via "Program control", see Subsection 4.6.12). The
functions are displayed irrespective of the selected menu.
Program blocks in which the block number is preceded by a slash are
skipped when you run the program (e.g. "/N100 ..."). Up to 10 program
levels can be hidden (e.g., "/6N100 .."; the 7th program level is
hidden)
References: /PG/ Programming Manual Fundamentals, Chapter 2.
n = active skip levels
If this function is active, execution is interrupted after every block that
triggers a function on the machine
(calculation blocks do not cause an interruption).
If this function is active, the part program blocks are executed as
follows: Each block is decoded separately and execution is interrupted
after every block.
If this function is active, the part program blocks are executed
individually in the cycle as follows:
Each block is decoded separately and execution is interrupted after
every block. Part program blocks are
- Traversing blocks
- Switching and auxiliary functions
- Blocks generated internally in the controller (e.g. blocks inserted
for tool radius compensation)
- Thread blocks after retraction
- Thread blocks with dry run feedrate
Thread blocks without dry run feedrate are an exception to this. In
such blocks, a stop is only performed at the end of the current thread
block. SBL2 can only be selected in the Reset state.
Either SBL1 or SBL2 can be selected!
This function can be activated only in the "Single block" state.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
2
01/2008
© S iemens AG 2008 All rights reserved.