Copying And Inserting - Siemens SINUMERIK 840Di sl Operating Manual

7
Services operating area
7.2 Managing data
Loadable compile cycles
Load a compile cycle

7.2.3 Copying and inserting

Copy compile cycles
Manage
data
7-368
You can use the HMI user interface to transfer the loadable compile
cycles (CC) easily to the NC using an NC card. Further storage
locations are any external drive, such as a disk drive, USB memory
module or network drives 1 to 4. This storage location appears in the
Service operating area under "Manage data".
You can also use the SinuCom NC or SINUCOPY-FFS
commissioning tool to transfer the loadable compile cycles into the
control.
Each time the NC is booted, all loadable compile cycles with the
extension .ELF, which are available in the /_N_CCOEM.DIR directory,
are automatically loaded into the NCK system software. Loadable
compile cycles are always loaded on an NCU reset.
For a detailed description of how to install compile cycles, please see:
/FB3/, TE0 Installation and Activation of Loadable Compile Cycles.
Function
Following a reset, the optionally available compile cycles are stored on
the NCU in the Flash File System (FFS) in directory /_N_CCOEM.DIR
and can be copied selectively from/to an external drive, disk or NC
card.
It is thus possible to archive individual compile cycles.
The "Insert" function is available in addition to "Copy".
You can copy
1. A single file,
2. Several files or
3. A complete directory.
You can display any existing compile cycles in the Diagnostics
operating area under Service displays/Version/Compile cycles.
Sequence of operations
Press the "Manage data" softkey.
The horizontal and vertical softkey bars change.
Select the source files that you wish to copy.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
7
01/2008
© Siemens AG 2008 All rights reserved.