Siemens SINUMERIK 840Di sl Operating Manual page 151

4
01/2008
Cycle Stop
Overstore
Cycle Start
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Overstore without single block:
The main menu for "AUTO" mode is selected.
Stop the program by pressing "NC Stop".
The "Overstore" window is opened.
In this window, you can now enter the NC blocks that are to be
executed.
The blocks you have entered are executed, the "Current block"
window is opened and the softkeys disappear. The "Overstore"
window and associated softkeys are not displayed again until the
control switches to the "Channel interrupted", "NC Stop" or "NC
Reset" state.
More blocks can be added (to the overstore buffer) when these blocks
have been executed.
Additional information
• You can close the window and exit the Overstore function by
pressing the "Recall" key. You have now exited the Overstore
function.
• You cannot change operating modes until you have deselected
"Overstore" with the "Recall" key.
• The program that was selected before Overstore is now resumed
in "AUTO" mode when you press "NC Start" again.
• Overstore does not alter the programs stored in the part program
memory.
Machine operating area
4.6 Automatic mode
4
4-151