Siemens SINUMERIK 840Di sl Operating Manual page 209

5
01/2008
Offsets
Edge +
Edge -
New
Delete
Abort
OK
Cut. edge
user data
Tool user
data
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Tools in the tool catalog are used as a basis for real tools. It is
recommended to define only data actually required in that exact form
for several real tools. This helps to minimize the amount of changes
required later.
Tool data are displayed and edited as follows:
• Tool offset data (cutting edge data)
The tool offset data window is displayed. The data of the first
cutting edge are listed in a table. The vertical softkey bar changes.
Enter the required settings.
The following functions are available for editing the cutting edge
data:
The cutting edge data of the next defined cutting edge are
displayed in a table.
The data of the previous cutting edge are listed.
A new cutting edge is created for the tool.
The current cutting edge and all the data defined for the cutting
edge are deleted after a prompt.
Select "Abort" to discard the changes.
No new cutting edge is created.
Save the cutting edge data with "OK".
A new cutting edge is created (if defined).
• Cutting edge user data (if configured)
Switches to the "Cutting edge user data" input screen.
Up to 10 user-specific cutting edge data are displayed here.
Enter the required settings in the table.
• Tool user data (if configured)
Switches to the "Tool user data" input screen.
Up to 10 user-specific tool data are displayed here.
Enter the required settings in the table.
Parameters operating area
5.3 Tool management
5
5-209