Siemens SINUMERIK 840Di sl Operating Manual page 194

5
Parameters operating area
5.3 Tool management
Loc. dep.
offsets
Edge +
Edge -
Delete
edge
<<
5-194
The tool offsets (identical to the cutting edge data table) and the local
offsets of the currently selected cutting edge are displayed and can be
edited.
The following options are available:
• Values can be defined for Length1, Length2, Length3 and Radius1
for each parameter.
• Up to six local offsets (DL1...DL6) are possible (according to the
machine manufacturer's configuration).
• Setup values and wear values can be defined for each offset.
In the individual tables, this softkey displays the data/offsets of the
next cutting edge for editing.
The data/offsets of the previous cutting edge are displayed and can
be edited.
In the table, select the cutting edge you want to delete (by positioning
the cursor).
The cutting edge is deleted when you activate the softkey.
Important: There is no separate prompt.
The D number is removed from the table and can be reallocated.
Terminates input of the tool data and returns to the table displayed
previously.
Note
You can enter individual tool data items directly in the current list,
provided you have the necessary access authorization and the data
are displayed in the list (the list structure is configurable).
Select the value to be edited and enter the required data. The system
automatically switches to edit mode.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
© Siemens AG 2008 All rights reserved.