Siemens SINUMERIK 840Di sl Operating Manual page 318

6
"Program" operating area
6.8 Program simulation
Notes
"Details..." menu
Standard horizontal
Milling
Top
or
view
Front-
or
view
Side
or
view
Wire
or
model
6-318
1. On simulation START and program change, any 3D view currently
displayed is automatically deselected and replaced by a
technology-specific default view.
2. If you repeat machining simulation START after end of program
M2/M30 of the last program to be simulated, the simulation
channels are usually RESET and the simulation graphic reset if no
machining list has been activated with the "Channel/spindle"
softkey.
3. If the machining list under "Channel/spindle" is activated, the
overlay principle takes effect for the listed programs, where global
reset in combination with a simulation START is only activated
after a query on the last M2/M30.
4. New selection or reselection of one of the listed workpiece views is
implicitly linked to automatic screen size adjustment.
5. In the case of "turning" technology, drills and milling cutters
in the G18 plane can only be displayed as polymarkers (cross
symbol) in the side views. Only the tool center point path
without the tool body is displayed.
The tool is visible on the front face view (G17) or on peripheral
surface processing (G19).
Assuming 2 window views with no alarm status:
• Default when milling: "Top view and front view"
• Default when turning: "Half-section and wire model"
With 2 window views only:
Turning
Free selection of the different views in window activated by means of
External
view
Half
ditto
section
ditto
Full
section
ditto
Wire
model
ditto
Face
end
Periph.
ditto
surface
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
6
01/2008
© Siemens AG 2008 All rights reserved.