Siemens SINUMERIK 840Di sl Operating Manual page 154

4
Machine operating area
4.6 Automatic mode
Program
control
Skip blocks
Skip
blocks
References
4-154
Sequence of operations
"AUTO" or "MDA" mode is selected in the "Machine" operating area.
Press the "Program control" horizontal softkey.
Another window pane, "Program control", appears on the main
screen. The softkey bars change and the softkeys of the skip blocks
and block display appear in the vertical menu.
Each actuation of the "toggle key" activates or deactivates the
selected program control function.
The block display appears in an extended "program control" window
pane and can be selected with the "Block display" vertical softkey.
Press the "Skip blocks" vertical softkey.
The "Skip blocks" vertical softkey is only displayed if more than 1 skip
level was set in MD 9423: MA_MAX_SKP_LEVEL. The levels to be
skipped can only be changed when the control is in the Stop/Reset
state.
Place the cursor at the required position.
Each press of the "Toggle key" activates or deactivates the selected
skip level in the "Program control" window.
Additional information
The entries influence the program control display (see Section 2.5).
The program control display is output irrespective of the selected
menu.
For further information about how to program skip levels, please see:
/PG/, Programming Guide Fundamentals
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
4
01/2008
© Siemens AG 2008 All rights reserved.