Siemens SINUMERIK 840Di sl Operating Manual page 153

4
01/2008
SKP:
Activate skip levels
Display activated skip levels If more than one skip level is active, the right column indicates
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
It is possible to skip blocks, which are not to be executed every time
the program runs (10 skip levels).
Blocks to be skipped are indicated in the part program by an oblique
"/" before the block number. The skip levels in the part program are
specified by "/0" or by "/" to "/9". You can activate/deactivate skip
levels in the following window:
Program control
SKP: Skip blocks
Skip /
Skip /1
Skip /2
Skip /2
Skip /3
Skip /4
Skip /5
Skip /6
Skip /7
Skip /8
Skip /9
This program control window is displayed only if more than 1 skip level
was set via machine data. Only the set skip levels are displayed.
Changes to machine data are described in Section 9.1.
whether the PLC has transmitted the skip level selection to the NC.
This allows you to see from the top window which level
• is selected, but
• selected and
• deselected and
• deselected and
Machine operating area
4.6 Automatic mode
active
not yet active
active
active
not active.
4
4-153