Siemens SINUMERIK 840Di sl Operating Manual page 59

2
01/2008
References
Simulation
Recompile
OK
Renumber
References
© S iemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
/PGC/, Programming Guide Cycles
Simulation
The simulation is called (see /BA/, Operator's Guide, Interactive
programming or Chapter 6 Program operating area).
The "Simulation" softkey is displayed only if the simulation function
can be called in the current operating situation.
Recompile
If program steps (cycle/contour) have already been parameterized but
must be changed, you can display and edit the parameter values with
their meanings.
Position the cursor in the text editor on the line with the program step
(contour/cycle) whose parameters you wish to change.
A screen form containing the parameter settings for the selected
cycle/contour appears on the screen.
Change the parameters.
The part program block is automatically inserted in the part program
with the new parameter settings.
The block numbering in the program shown in the editor is executed
again according to the values defined under the "Settings" softkey.
When using cycle support in the part program, additional comment
lines are generated in front of and behind the cycle call and used for
recompilation.
These lines start with ;# ... .
When cycles are called that were directly recorded with the editor (or
even when "old" cycles are called), this information is missing.
The ;#-lines, which are the additions required for screen form support,
are generated during recompilation of these cycle calls. As a result,
the length of the part program is expanded by a number of lines.
Commissioning Manual HMI-Advanced: "Expand User Interface"
(BE1)
Operator Components/Operating Sequences
2.5 General operating sequences
2
2-59