Edit The Part Program In The Ascii Editor - Siemens SINUMERIK 840Di sl Operating Manual

2
01/2008

2.5.6 Edit the part program in the ASCII editor

© S iemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Function
The ASCII editor provides you with the following functions:
− Switch between insert and overwrite mode
− Select, copy, delete block
− Paste block
− Position cursor / find/replace text
− Saving a file
− Create contour (programming support)
− Parameterize cycles (drilling, milling, turning)
− Start simulation
− Recompile (cycles, free contour programming)
− Renumbering blocks
− Change settings
− 2. Open file
Additional information
A part program selected in the NC can generally only be edited when
the channel is in the reset state. When a part program is selected and
the relevant channel is in the "Channel Reset" state, the program can
be fully edited.
The end of block character is not displayed as "
displayed as "¶".
Please note:
It is possible to edit a program both directly in the NC and on the hard
disk in the ASCII editor. How programs are saved on the hard disk is
determined by settings.
Sequence of operations
The following functions are fully enabled in the Program and Services
operating areas but only partially in the Machine operating area.
In the Machine operating area, the ASCII editor is called via the
program editor, in Services, by selecting a file in the file manager.
You have selected the file you wish to edit in the directory
and pressed the "Enter" key,
the vertical softkey bar changes. Your selected file is opened in the
text editor.
Operator Components/Operating Sequences
2.5 General operating sequences
2
L
"; instead it is
F
2-55